Note: Some features described here may not be supported by all control systems. Check your control panel’s Installation and Operation Guide for details.

• Traditional familiar appearance

SIGA-270 models feature our familiar teardrop design, coupled with a simple positive pull action and sturdy die-cast metal body.

• One stage (GA), two stage (pre-signal), and double action models

SIGA-270 models are also available for one or two stage alarm systems. The single stage double action SIGA-278 also features a rugged Lexan housing in addition to a keyed reset mechanism.

• Break glass operation

An up-front visible glass rod on the SIGA-270 discourages tampering.

• Intelligent device with integral microprocessor

All decisions are made at the station allowing lower communication speed while substantially improving control panel response time. Additionally, it is less sensitive to line noise and loop wiring properties; twisted or shielded wire is not required.

• ADA Compliant

Meets ADA requirements for manual pull stations.

• Electronic Addressing with Non-volatile memory Permanently stores programmable address, serial number, type of device, and job number. Automatically updates historic information including hours of operation, last maintenance date, number of alarms and troubles, and time and date of last
• Automatic device mapping

Each station transmits wiring information to the loop controller regarding its location with respect to other devices on the circuit.

• Stand-alone operation

The station inputs an alarm even if the loop controller’s polling interrogation stops.

• Diagnostic LEDs

Status LEDs; flashing GREEN shows normal polling; flashing RED shows alarm state.

• Designed for high ambient temperature operation

Install in ambient temperatures up to 120 °F (49 °C).